Munters Communicator 2.0 - 3.9 Connecting to Peripheral Devices; 3.10 Connecting the T-Box to External Devices

© Munters AB, 2019 12
3.10 Connecting the Communicator 2.0 to a Controller or RLINK One
The only step in installing a Communicator 2.0 that requires wiring is when connecting the Communicator
2.0 to the controllers or to the RLINK One RF Communication Unit.
•
Plug the 25 plug connector into Communicator External Box cable.
Figure 4: External Box – Communicator 2.0 Cable
•
Controller Connection
•
RLINK One Connection
CAUTION You can connect an RLINK One and a controller to the same Junction Box, using the same
ports shown in the following diagram. Do not wire the Junction Box or controller to the
Junction Box’s upper communication ports.