© Munters AB, 2019 7
3 Hardware Installation
This document details how to install Munters' Communicator 2.0 unit. Installation can include the
following:
•
Precautions
•
Communicator 2.0 Ports
•
Interior
•
Mounting the Communicator 2.0
•
Grounding
•
Connecting the Communicator 2.0 to the Internet
•
Connecting the Communicator 2.0 to a Phone Line
•
Attaching the Antenna
•
Connecting the Communicator 2.0 to a Peripheral Device
•
Connecting the Communicator 2.0 to a Controller or RLINK One
•
Enabling SMS Messages
•
Testing the Battery
NOTE:
After installing the unit, check the LEDs (page 46) to make sure that everything is working as
required.
3.1 Precautions
Observe the following precautions when using your unit.
•
Keep the Communicator 2.0 as far as possible from heavy contactor boxes and other sources of
electrical interference.
•
Do not connect communication wire shields, which go from one house to another at both ends.
Connect them at one end only. Connection at both ends can cause ground loop currents to flow,
which reduce reliability.
•
The COM connection for communications is not the shield wire. The COM, RX and TX wires must
connect to each other at all controllers.
3.2 Communicator 2.0 Ports
Figure 1: External Ports
To Next Page
Loading...