© Munters AB, 2019 39
o
Phone Line alarm: Enable sending an alarm if the phone line is disconnected.
o
Line-Out Volume: Define the call volume.
NOTE:
The above two parameters require telephony connectivity to be enabled.
o
Voice Speech Speed: Define the text-to-speech playback speed.
o
About: These read-only parameters provide data for service technicians.
4. Click Save.
6.2 Adding Contacts
1. Click the Settings icon, select Alarm System, and click the Alarm Contacts tab.
2. Click . The following screen appears
3. Fill in:
•
Contact name
WARNING!
There must be at least one contact name or the alarms will not function!
•
Priority: If there is more than one contact, you can define the order in which the contacts receive
messages.
•
Voice Message Number/Text Message Number:
o
Add a number for an outside line if required.
o
Enter the exit code/country code/area code (if required) and the numbers. Enter
numbers only; do not enter dashes, spaces, or any other character (including a plus
(+) sign). For example, if the controller is in the US and the contact is in:
Harrisburg, Pennsylvania, dial: #1717XXXXXXX
London, England, dial: #0114420XXXXXXXX
# is the outside line number (if required)
•
Email address
NOTE:
To receive push notifications, use the email address used to activate each account. You can
enter any email address but only the activation address enables push notifications.
•
Message Type: Mark the checkbox(es) next to message type(s) that this contact is to receive.
To Next Page
Loading...
