Munters Communicator 2.0 - Disable Alarms; Testing the Communicator 2.0; Responding to Alarms; Responding to an Audio Message

© Munters AB, 2019 42
6.5 Disable Alarms
To disable an alarm, click the corresponding radio box.
NOTE All alarms are listed. However, there are alarms which cannot be disabled due to their
importance.
6.6 Testing the Communicator 2.0
• To test a communication function, on the Alarm Settings screen click:
o
Phone Line Test
o
Cellular Modem Test
o
COM Port(s) Test
o
Create Test Alarm
o
Send Email
o
Send Push Notifications
NOTE Testing can also be done via the Diagnostics screen (page 45).
6.7 Responding to Alarms
Upon receiving an alarm message (voice or SMS), you can respond to the message. The following
sections detail how to respond to these messages.
•
Responding to an Audio Message
•
Responding to a Text Message
6.7.1 R
ESPONDING TO AN
A
UDIO
M
ESSAGE
Communicator 2.0 sends voice messages to the designated people on the contact list. This section details
the procedure to follow when an audio alarm is received.
NOTE: This service is provided by the Communicator 2.0 ONLY if the contact is properly defined with
contacts and the "VOICE" service selected per contact.
Communicator only broadcasts its alarm message AFTER someone speaks into the phone. Any word or
sound is sufficient.