Munters Communicator 2.0 - RLINK One Connection; Wiring Topology

© Munters AB, 2019 14
3.10.2 RLINK O
NE
C
ONNECTION
•
Wire the Communicator External Box to the RLINK One as shown in the following diagram.
Figure 7: External Box – RLINK One Isolated RS-485 Connection
NOTE: RLINK One supports RS-485 infrastructure only.
3.10.3 W
IRING
T
OPOLOGY
When connecting the Communicator 2.0 to controllers via an RS-485 infrastructure, use one of the
following allowed topologies to ensure signal integrity.
Figure 8: Direct connections
Figure 9: T-Junction (permitted)