© Munters AB, 2019 21
4. Under Number of Houses to be Scanned, select at least one house (required). You can name
any house selected.
5. At the bottom of the screen click Activate.
6. The following screen appears:
•
At this point, you can use Communicator 2.0 to configure your controllers locally. Click .
•
To enable web control, click . RotemNet Web scans the controllers.
o
If a house was checked in the above screen but is not connected to the Communicator 2,
the scan fails. See House 3 in the graphic below.
To Next Page
Loading...
