:MX
2
Plus Dehumidification system
6!)Munten
6.2 General
Most
air treatment units require the same type
of
maintenance.
The
following paragraphs explain the
necessary basic rules.
Service
and
maintenance interval lengths are primarily determined
by
operating conditions
and
the
environment
in
which
the
unit is installed.
For
example,
if
the process air contains a
lot
of
dust, preventative
maintenance should
be
carried
out
at
shorter intervals.
The
same also applies
if
the
unit works intensively.
The
service levels for a standard service
and
maintenance
programme
are described
in
section
6.3,
Service
options.
The
control system is equipped with a service indicator.
It
is
programmed
at commissioning to give a service
alarm after
an
estimated
number
of
operating hours,
or
on
the preset date for the next service.
6.3 Service options
In
addition
to
commissioning
of
the unit there are four service options
(A
-D) as standard.
S.
Commissioning/ start-up.
A Inspection
and
if
necessary change
of
filter. General function check.
B.
In
addition
to
A, safety check
and
capacity, temperature
and
humidity regulation measurements.
C.
In
addition
to
B,
preventive replacement
of
some
components
after 3 years
of
operation.
D.
In
addition to C, preventive replacement
of
some
components
after 6 years
of
operation.
NOTE!
Always
contact
Munters
for
seNice
or
repair.
Operating
faults
can
occur
if
the
unit
is
maintained
insufficiently
or
incorrectly.
NOTE!
Commissioning/Start-up
inspection
"S"
by
Munters
is
mandatory
to
validate
the
full
warranty.
Munters service engineers have special equipment
and
rapid spare parts access to handle service
on
all
Munters products. All test equipment used by
our
personnel
to
ensure
proper
system balancing is certified
for accuracy.
Munters Service can offer a service plan adapted to suit the conditions
of
a specific installation. See contact
addresses
on
the back page
of
this manual.
6.4 Extended warranty
Munters offers
an
extended warranty
to
the standard terms
when
the
Customer
signs a service contract with
Munters. Details are available
on
request.
6.5 Cleaning
Use only a pH-neutral soapy water solution
and
a soft sponge for cleaning
of
the
unit
casing.
When
cleaning
the
inside, avoid contact with the
rotor
and
wipe
the
surfaces dry.
Use a vacuum cleaner with a
brush
head for the rotor. Contact Munters for instructions
if
vacuum cleaning
is
not
sufficient.
To Next Page
Loading...
