When you change a setting during operation, be sure to select "Backup" to save the setting that you
changed.If the printer returns to Normal without "Backup" being selected, the changed setting is not
saved.
Before using the Job Status items, please check the followings.
The values displayed in the Job Status are just standard values, not guarantee the accuracy.
If the print data includes no length data, all information will be displayed as “0”.
The “Remain” and “Remain Time” information can be checked in “4.4.8 Normal Display while Printing”.
To check the information of printed data, please refer to the below.
“5.8 Job Status menu”
Setup item Setting Description Reference
Pre Checks the current
temperature of Pre-heater.
Platen Checks the current
temperature of Platen
heater.
Temperature
（VJ-1638 only）
Dryer Checks the current
temperature of Dryer.
-
Pre-heater
(VJ-1638 only)
Off / 30ºC～50ºC Changes the temperature
of Pre-heater.
5.1.1.1.4 Pre-heater
menu (VJ-1638 only)
Platen heater
(VJ-1638 only)
Off / 30ºC～50ºC Changes the temperature
of Platen heater.
5.1.1.1.5 Platen
Heater
menu (VJ-1638 only)
Dryer
(VJ-1638 only)
Off / 30ºC～50ºC Changes the temperature
of Dryer.
5.1.1.1.6 Dryer menu
(VJ-1638 only)
PF Adjust -5.00%～0.00～5.00% Change the feed
adjustment value.
5.1.1.1.3 Media feed
compensation
Backup - • [Enter] key: Save the
changed setting.
-
ToDoLength Checks the length of data
currently printing (media
feeding direction).
-
Done Checks the already printed
length of data currently
printing.
-
Remain Checks the remaining
length of data currently
printing.
-
Job Status
Remain Time The remaining time to
complete the printing will
be displayed.
-
- - • [Cancel] key: The printer
returns to
Normal.
-
To Next Page
Loading...
