- 43 -
CONTROLS AND INSTRUMENTS 3
3
Engine stop switch
It is used to switch off the engine in an emergency. The ignition circuit is disabled, preventing the engine
from being restarted. To be able to restart the engine, return the switch to its original position.
NOTE
Under normal conditions, do not use this switch to shut off the engine.
Engine start button
It is used to start the engine and, when the engine is running, to select the different functions of the dis-
play installed on the instrument panel.
CAUTION
To avoid damaging the electrical equipment, be sure not to hold down the button for longer
than 5 consecutive seconds.
If, after some attempts, the engine does not start, refer to the chapter “TROUBLESHOOT-
ING” later in this manual.
Cold start (choke) lever
It facilitates cold starting by slightly enrichening the fuel-air mixture during start-up.
NOTE
This function must remain active only for a short time depending on the engine and environ-
mental temperature. As soon as the idle speed keeps the engine running, it is advisable to disa-
ble the control.
To Next Page
Loading...
