Myray Hyperion X5 2D - Page 43

41
EN
hyperion X5 2D/3D - TECHNICAL MANUAL
EN
CONTROL BOARDS DESCRIPTION
LED ID COLOR NAME ON BOARD DESCRIPTION
DL10 GREEN MOTR
On if R motor is active. If ashing the motor is in error (disconnected,
short-circuit, overheating, broken driver)
DL11 GREEN PROG FPGA programmed, normally on
DL12 GREEN RUN FPGA on, normally ashing (3Hz)
DL13 GREEN SYNC POWER-LOGIC sync signal, normally off.
DL14 GREEN ENABLE
Inverter enabled signal from LOGIC board, normally on. Off during
standby or in error condition.
DL15 GREEN ACK Acknowledged signal from LOGIC board, always on.
DL16 GREEN XRAY
X-ray emission signal from Power board. Normally off, on during
emission.
DL17 GREEN SD_ON Not used.
DL18 YELLOW ACT LAN activity LED. Normally ashing.
DL19 GREEN LINK LAN connection estabilished. Normally on.
DL22 GREEN 3.3V 3.3V CPU tension present, normally on
DL23 GREEN 24V 24V tension present, normally on
DL24 GREEN 5.0V 5V CPU tension present, normally on
DL25 GREEN 1.2V 1.2V CPU tension present, normally on
DL32 GREEN 48V R axis Motor tension present, normally on
DL33 GREEN FCR R axis photocell. On if photocell is obscured or disconnected/broken.
DL35 GREEN Not used
DL36 GREEN FCX Not used
DL38 GREEN 48V Y axis Motor tension present, normally on
DL39 GREEN FCY Y axis photocell. On if photocell is obscured or disconnected/broken.
DL42 GREEN EXP_OK_PAN Exposure OK signal from sensor, normally off.
DL43 GREEN PAN_IN
Sensor present, normally off. On if broken cable or sensor interface
board is disconnected.
DL46 GREEN PAN_ON
48V Sensor power supply ok. Normally on. Off during standby or in
error condition on sensor or interface board.
DL49 GREEN 48V 48V from power board on. Off during standby or in error condition.
DL51 GREEN ENB_PAN
48V enabled on sensor. Normally on. Off during standby or in error
condition on sensor or interface board.
DL53 GREEN CHIN_L Not used
DL54 GREEN CHIN_R Not used