N-Com B902 User Manual

EN
16
4. BASIC FUNCTIONS
Note
: Before using the N-Com device for the first time, recharge the battery completely for at least
10 hours. To obtain best performances from the battery, it is recommended to completely recharge
the battery the first few times. Afterwards, you can recharge the battery for shorter periods. Whenever
possible, it is best to recharge the battery completely.
System ON
Press “
ON
” and keep it pressed for about 2 seconds, until the LEDs turn
on and you hear the voice announcement.
System OFF
Press “
ON
” and keep it pressed for about 6 seconds, until the LEDs turn
off and you hear the voice announcement.
N.B.
: during the switch on/switch off phase of the B902L system, the ESS light flashes for a few
seconds.
4.1. Volume adjustment
You can easily adjust the volume by tapping the “” or the “

” key. You will hear a beep when the
volume reaches the maximum or minimum level.
Some volume parameters can be adjusted through the N-Com EASYSET APP for smartphone or the
N-Com EASYSET computer program (chapter 4.4).
N.B.
: The volume level set during the trip is not stored when the system is turned off. Each time the
N-Com system is switched on, the audio goes back to the set default volume level.
4.2. Auto On / Off function
If the helmet does no move for more than 60 seconds, the B902L system goes into “deep sleep”
mode. The system is completely turned on as soon as movement is detected.
If the system is in “deep sleep” mode for more than 3 days, it turns off completely. To turn it back on,
the “
ON
” key need to be pressed.
The “Auto On / Off” function is enabled by default on the device.
You can enable / disable the function from the Configuration Menu (Chapter 6).
4.3. Multi-language voice messages
The N-Com system features voice messages that provide information on the system and on the active
functions.
The language set by default is English. The language of the voice messages may be changed through
the specific firmware installable with the N-Com EASYSET program. Please refer to the online HELP for
instructions on how to change the language settings.
Available languages: Italian, English, French, German, Spanish, Dutch.
The default function is enabled on the device.
You can enable / disable the “VOICE ANNOUNCEMENTS” function by using the
N-Com EASYSET program or the N-Com EASYSET APP.

N-Com B902 Specifications

General

Bluetooth version	4.1
Battery life	15 hours
Smartphone connection	Yes
Music sharing	Yes
FM radio	Yes
GPS connection	Yes
VOX	Yes
Waterproof Rating	IP67
Intercom range	700 m
Intercom conference	Up to 4 riders