N-Com B902 User Manual

31
18. REMOTE CONTROL
The B902L device can be controlled by using a remote control (sold separately), so that you do not
have to take your hands off the handlebars to use the keypad.
The N-Com system is compatible with the RC4 Remote Control by SENA.
The following table shows the correspondence of the keys:
N
-
COM SYSTEM
▲
▼
ON
N
SENA RC4
+
-
CENTRAL
KEY
MULTI
-
FUNCTION
KEY
Proceed as follows to pair up the N-Com system to the RC4 Remote Control:
• Make sure the RC4 is switched off.
• Put the RC4 in pair up mode: press the key “+” and keep it pressed for about 8 seconds.
• Make sure the B902L is switched off.
• Put the B902 system in the “Pairing up” menu: press the “
ON
” key and keep it pressed for 4
seconds, until you hear the voice announcement “
Pairing up Menu
”.
• Press the “” key to access the “Remote control pair up” mode.
• Press the “
ON
” key on the N-Com system keypad.
• After a few seconds, the connection between the two devices is confirmed by the voice
announcement “
Remote control connected
”.
N.B.:
The affiliation is saved by both the helmet and the remote control and it is not lost when the two
systems are turned off. Hence this procedure must only be carried out once.

N-Com B902 Specifications

General

Bluetooth version	4.1
Battery life	15 hours
Smartphone connection	Yes
Music sharing	Yes
FM radio	Yes
GPS connection	Yes
VOX	Yes
Waterproof Rating	IP67
Intercom range	700 m
Intercom conference	Up to 4 riders