N-Com B902 User Manual

EN
30
N.B.:
• During use of the UNIVERSAL INTERCOM, the B902 system keeps the connection active to the
MAIN DEVICE only (and not to the SECOND MOBILE PHONE or to the SATELLITE NAVIGATOR).
• The intercom system connected to N-Com B902 may not allow simultaneous connection to a
mobile phone.
• Only one system paired up in Universal Intercom mode can be stored.
17.3. Universal Conference (chain intercom)
The “Universal Conference” mode can be used to connect in conference call N-Com systems of the
“900” series and one system paired up in Universal Intercom mode.
The connection procedure is outlined in the diagram provided here below:
1. System A must have been paired up beforehand to two B systems (Universal Intercom pair
up) and C.
2. System A has to initiate the first intercom connection with system B (Universal Intercom), by
pressing the relative intercom connection command.
3. At this point, system C can join the intercom conference call, establishing an intercom
connection with system A.
4. The three systems are now in intercom conference call mode and can talk to each other at
the same time.
5. In case you wish to add another system (D), the latter must be paired up beforehand to
system C. Press the relative connection command to start a 4-participant intercom
conference call.
Note:
The “ Universal Conference ” mode can also be used by connecting only “900” series N-Com
systems”.
Note
: The “ Universal Conference ” mode can also be used by connecting “900” series N-Com systems
with other N- Com devices (B601, B5, B1.4, etc.).

N-Com B902 Specifications

General

Bluetooth version	4.1
Battery life	15 hours
Smartphone connection	Yes
Music sharing	Yes
FM radio	Yes
GPS connection	Yes
VOX	Yes
Waterproof Rating	IP67
Intercom range	700 m
Intercom conference	Up to 4 riders