EN
18
Press the “
ON
” confirmation key to delete all Bluetooth devices stored in memory.
I.
Exiting the configuration*
To exit the “Pairing up” menu, press the key “” or “
” until you hear the voice announcement
“
Exit the configuration
”. Press the “
ON
” confirmation key to exit the “Pairing up” menu.
If no key is pressed within 15 seconds, the device automatically exits the “Pairing up” menu.
6.
CONFIGURATION MENU
All the settings of the N-Com system are carried out in this mode.
To access the Configuration Menu starting with the N-Com switched on, press the keys “” and “”
for 4 seconds.
Once in the “Configuration” menu, press the keys“” and “
” to scroll through the various menu
items.
In the items marked with an “
*
”, it is possible to enable / disable the function by pressing the “
ON
” key
to confirm.
The following items make up the “Configuration” menu:
A.
Speed dial*
(chapter 9.1)
B.
Smart Navi System
(chapter 9.3)
C.
Auto On / Off
(chapter 4.2)
D.
Audio Multitasking
(cap. 14)
E.
Audio boost *
By enabling the “Audio boost” (Audio Boost), all the audio sources inside the device will be
reproduced at a higher and potentially less clear volume.
Press the “
ON
” confirmation key to enable / disable the function, which is not enabled by default
on the device.
F.
ESS sensitivity*
(chapter 15.1)
G.
Reset*
In order to restore the factory settings of the device, press the key “” or “
” until you hear the
voice message “
Factory Reset
”.
Press the “
ON
” confirmation key to restore all the factory settings of the device.
H.
Exiting the configuration*
To exit the “Configuration” menu, press the key “” or “
” until you hear the voice
announcement “
Exit the configuration
”.
Press the “
ON
” confirmation key to exit the “Configuration” menu.
If no key is pressed within 15 seconds, the device automatically exits the “Configuration” menu.
To Next Page
Loading...
Need help?
General
