23
12.
NAVIGATOR PAIR UP
B902 system is compatible with the most common satellite navigators for motorcycles. For a list of
compatible models and additional details, visit the website www.n-com.it
• Make sure the B902 is turned off.
• Put the system in the “Pairing up” menu: press the “
ON
” key and keep it pressed for 4
seconds,
until you hear the voice announcement “
Pairing up Menu
”.
• Press the “”key until you reach the option “
GPS Pair up
”.
• Activate the search of Bluetooth devices on the navigator.
• Select the N-Com system from the list. If a password is requested, enter the code 0000 (four
zeros).
• After a few seconds, the connection between the two devices is activated.
N.B.
:
The pair up is stored by both the helmet and the navigator hence it is not lost when they are
switched off. This means that this procedure needs to be carried out only once. Once the Bluetooth
device has been paired up, connection is automatic when the system is turned on.
N.B.
: Intercom connection is automatically cut off every time the navigator gives directions and
restored at the end of the message from the navigator.
Should you wish to keep the navigator audio active even during the intercom connection, please
refer to chapter 14 “Audio Multitasking”.
13.
FM RADIO
Turning on the radio
Press the “
ON
” key twice
Turning off the radio
Press the “
ON
” key twice.
New station automatic search
Press “” and keep it pressed for 2 seconds.
Pre-setting a radio station (max.
6 stations)
you hear the word “
Preset
”. Select the pre-setting position using
the keys “” and “
”. Saving is confirmed by means of a voice
message.
Changing radio stations (among
the pre-set ones)
Press “” and keep it pressed for 2 seconds.
This function can also be turned on using the “N-Com EASYSET” programme or
through the “N-Com EASYSET App” for Smartphone Android, iPhone, iPad.
To Next Page
Loading...
Need help?
General
