EN
28
by pressing the “” key for 5 seconds. By doing so, the system will not attempt to connect to the last
connected channel every time a word is spoken out loud.
The temporary disabling of the VOX function is then removed the first time the N-Com device is
turned off; so, if the VOX Intercom is enabled (from PC or APP), it will be restored the next time the
device is switched on.
N.B.
: The VOX Intercom function can be used
EXCLUSIVELY
with “900” series N-Com systems.
16.4.
Smart Conference
(Group Intercom)
Thanks to the “Smart Conference” function, you can start the conference communication between N-
Com intercom systems of the “900” series previously paired up and saved in the 3 available channels.
All systems must be turned on and available within the connection range.
1. Each system must have been previously paired up to all the other systems: B, C and D.
2. Any system can press the “
n
” key for 2 seconds to activate the Group Conference or to start
a conference communication between all the systems.
3. In the case where one of the systems presses the “
n
” key or falls outside the connection
range, the group intercom is interrupted.
connection
key for 2 seconds. Activation
is confirmed by a beep in the
helmet and by the voice message “
Group Intercom
”
.
disconnection
key. Disconnection is confirmed by the voice
announcement “
Group Intercom terminated
”.
N.B.:
During a “
Smart Conference
” call, connection to the mobile phones of all participants is
temporarily cut off. When the conference call ends, all phones automatically reconnect to their own
intercom system.
Note
: The “
Smart Conference
” mode can be used
EXCLUSIVELY
with “900” series N-Com systems”.
Note
: The “
Smart Conference
” mode
CANNOT
be used with systems paired up in Universal Intercom
mode (chapter 17).
To Next Page
Loading...
Need help?
General
