4 of 26
GT 710-8710 OPUS Low Energy Swing Doors Quick Set-Up and Parts Guide www.NabcoEntrances.com
P/N C-00178 Rev 12-20-17
CHAPTER 3: SCOPE
SECTION 31: To the Installer
• Turn OFF all power to the Automatic Door if a Safety System is not working.
• Instruct the Owner to keep all power turned OFF until corrective action can be achieved
by a NABCO trained technician. Failure to follow these practices may result in serious
consequences.
• NEVER leave a Door operating without all Safety detection systems operational.
SECTION 32: Objecve
A pedestrian Door that does not have Its glass sections installed at the Factory
shall specify that the glazing material employed is to comply with the requirement in UL 325
par.29.5.1:
“The glazing material in both xed and sliding panels of all sliding doors and in all
unframed swinging doors shall comply with the requirements in the Performance
Specicaons and Methods of Test for Safety Glazing Material Used in Buildings,
ANSI Z971 Glazing material for other pedestrian doors shall also comply with ANSI
Z971, except that single strength or heavier glass may be used for those porons
of doors involving a glazed area of less than 1
2
(09 m
2
) and having no dimension
greater than 18 in (457 mm)”
CHAPTER 4: INSTALL THE HEADER
DN 1376
Building Wall
Space between Building Wall
and Face of Door must be at
least 2inches (or more)
Figure 1 Inswing Door Gap
To Next Page
Loading...
Need help?
General
