9 of 26
www.NabcoEntrances.com GT 710-8710 OPUS Low Energy Swing Doors Quick Set-Up and Parts Guide
Rev 12-20-17 P/N C-00178
CHAPTER 5: INSTALL THE BOTTOM HALF OF OUTSWING ARM
SECTION 51: Mark Locaon of Arm Shoe
DN 1112
1-1/2”
Dim. A
Center mark for
fi rst Sex Bolt Hole
Center Pivot
Bu /Off set
(Inner Edge of Door Jamb)
Bu Hinge
ON
BACK
CHECK
SWITCH
DOOR
CLOSED
SWITCH
FOR
XXX HAND
UNITS
1413121110
98
7
6
54
321
16-15/16”
Figure 9 Arm Shoe Location
Table 1 Dimension “A” Arm Shoe Mounting Locations
Outswing
Model Pivot Type With Fingerguard No Fingerguard
N/A 16-15/16”
N/A 16-15/16”
SECTION 52: Cut the Threaded Rod
DN 1117
Threaded Rod
Swing Arm
Figure 10 Disassemble the Outswing Arm
DN 1342
Link
Nut
Threaded Rod
Arm Shoe
Figure 11 Remove the Link
To Next Page
Loading...
Need help?
General
