Rev. 3-12-13 Part #15-9000-30
www.NabcoEntrances.com U30 Microprocessor Control
4-13 Inial Startup
Press TEST to ensure Door behavior is based on current settings.
a.
9. STD FUNCTION Y N message will be displayed after the Test is completed.
a. This concludes the initial setup to factory settings.
If the U30 Microprocessor Control:
X Does not need to be programmed with custom settings:
• Disconnect the Handy Terminal and instruct the building owner of the Slide
door’s operation.
X Does need to be programmed with custom settings:
• Please refer to Chapter 5 “Adjustment Procedures” for detailed information.
To Next Page
Loading...
