Scope 1-4
U30 Microprocessor Control www.NabcoEntrances.com
Part #15-9000-30 Rev. 3-12-13
CHAPTER 1: SCOPE
Secon 1a: To the Installer
The purpose of this manual is to familiarize the installer and purchaser with the proper setup and
programming of the U30 Microprocessor Control. It is essential that this equipment be properly
installed and operational before the door is used by the public. It is the installer’s responsibility to
inspect the operation of the entrance system to be sure it complies with any applicable standards.
In the United States, ANSI Standard 156.10 is used to cover Slide door systems. Other local
standards or codes may apply. Use them in addition to the ANSI standards.
Instruct the building owners and operator on the essentials of the operation of the U30
Microprocessor Control. The owner should follow these instructions to determine whether the
door is operating properly and should immediately call for service if there is any malfunction.
Secon 1b: Objecve
The U30 Microprocessor Control is designed to be installed within the Header of all Slide door
systems. This manual offers step by step instructions.
To Next Page
Loading...
Need help?
General
