Nacra F16 - Raising the Jib; Lowering the Jib

NACRA EMPOWERING SAILORS SINS 1975
5.2 Raising the Jib
li
pull
2. Raise the jib unl the S-hook is pulled through
the ring.
3. Gently pull the jib down to lock the S-hook in
the ring.
1. Hook the jib on the S-hook. Close the
zipper while raising , with the jibhalyard
zipped in with the jibhalyard in between.
4. Feed the jibdownhall line through the 16mm-
block located on the starboard side next to the
compression pole. Go through the ring on the
tack of the sail and loop around the pole in or-
der to e it around the ouholderbase.
5. Aach the jibsheet small to the
clew of the sail
Note: the jibdownhall is
only standard on the
1. To lower the jib release the jibdownhall and the
jibsheet small.
2. Raise the jib a bit and pull on the other line,
while keeping tension on both lines, in order to
unlock the S-hook of the ring
5.3 Lowering the jib