IDENTIFICATION OF CONTROLS
FRONT PANEL
1 STANDBY BUTTON
• Press Standby button to switch ON the C 328 from standby mode.
When the C 328 is powered up from standby mode, this indicator
will change in color from amber to red and nally blue to indicate
operating mode.
• Pressing Standby button again switches back C 328 to standby
mode. The Power indicator will change to amber color.
• The Standby button cannot activate the C 328 if the rear panel
POWER switch is o.
IMPORTANT NOTES
For the Standby button to activate, the following must occur:
a The supplied power cord from the C 328 must be plugged in to a
power source.
b The rear panel POWER switch must be set to ON.
2 POWER INDICATOR
• This indicator will be amber when the C 328 is in standby mode.
• When the C 328 is powered up from standby mode, this indicator
will change in color from amber to red and nally blue to indicate
operating mode.
3 HEADPHONE
• A 1/4” stereo jack socket is supplied for headphone listening and
will work with conventional headphones of any impedance.
• Use a suitable adapter to connect headphones with other types of
sockets, such as 3.5mm “personal stereo” jack plugs.
4 a SOURCE s
• Press a SOURCE or SOURCE s to select Sources.
5 DISPLAY
• Show visual indicators of the Source names, Bass EQ and volume
level.
6 REMOTE SENSOR
• Point the AMP 3 remote control at the remote sensor and press the
buttons.
• Do not expose the remote sensor of the C 328 to a strong light
source such as direct sunlight or illumination. If you do so, you may
not be able to operate the C 328 with the remote control.
Distance: About 23ft (7m) from the front of the remote sensor.
Angle: About 30° in each direction of the front of the remote sensor.
7 BASS EQ
• Bass EQ boosts overall bass response by at least 6 dB. “BASS EQ” is
illuminated in the display with BASS EQ enabled.
• Toggle to enable or disable BASS EQ.
8 VOLUME
• The VOLUME control adjusts the overall loudness of the signal
sent to the speakers and headphone. The Volume control is
characterized by perfect signal tracking and channel balance. It
provides a highly linear and low noise operation.
• Turn clockwise to increase the volume level and counter clockwise
to lower it.
• The default volume level is -20dB.
© NAD C328
7 81 2 3 4 65
5
To Next Page
Loading...
