12 SPEAKERS
• Connect C 328’s Right speaker terminals marked “R +” and “R-” to
the corresponding “+” and “-“ terminals of your designated right
speaker. Repeat the same for C 328’s Left speaker terminals and
corresponding left speaker.
• Double check the speaker connections before powering up the
C 328.
IMPORTANT NOTES
• The blue terminals must never be connected to ground (earth).
• Never connect the blue terminals together or to any common ground
device.
• Do not connect the output of this amplier to any headphone adapter,
speaker switch or any device that uses common ground for left and
right channels.
NOTES
• Use 16 gauge (American Wire Gauge or AWG) or lower stranded wire.
Connections to the C 328 can be made with banana-type plugs.
• Bare wire or pins can also be used by loosening the terminal’s plastic
nut, making a clean, neat connection and re-tightening. To minimize
the danger of a short circuit, ensure that only 1/2-inch of exposed wire
or pin is used to connect and no loose strands of speaker wire.
IDENTIFICATION OF CONTROLS
REAR PANEL
7
To Next Page
Loading...
