NAD C 390DD User Manual

CONDITION POSSIBLE CAUSES POSSIBLE SOLUTIONS
No “Computer” audio. • Sound or Audio device setting of your PC or Mac
is not set to “NAD USB Audio”.
• Set your PC or Mac Audio or Sound device
setting to “NAD USB Audio”.
• No music les being played back from your PC
or Mac.
• Playback a music le from your computer.
Cannot power ON the C 390DD. • Rear panel POWER switched o. • Set to “ON” the rear panel POWER switch and
then press front panel Standby button.
VFD is dim. • Low brightness level of VFD is selected. • Toggle [DIMMER] button until desired
brightness level.
VFD show “No les found” even if a
USB device with les is connected.
• There are no applicable MP3/WMA/FLAC les
available in the USB device.
• Load MP3/WMA/FLAC les in the USB device for
playback.
C 390DD does not respond to remote
control commands.
• Batteries are at or incorrectly inserted. • Check batteries.
• Infrared receiver (IR) window of C 390DD or IR
transmitter of the remote control is obstructed.
• Check IR windows and ensure clear line-of-sight
from remote to C 390DD.
• C 390DD front panel is in very bright sunlight or
ambient light.
• Reduce sunlight/room lighting.
• IR Channel setting of C 390DD is dierent with
the IR Channel setting of the remote control.
• Ensure that both C 390DD and the remote
control are set to the IR Channel setting.
RESTORING C 390DD TO ITS FACTORY DEFAULT SETTINGS
Press and hold front panel together front panel buttons [a SOURCE] and [SOURCE s] until the VFD shows “Factory Reset”. The C 390DD is now restored to its
factory default settings.
REFERENCE
TROUBLESHOOTING
22
ENGLISH FRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSKA РУССКИЙ

NAD C 390DD Specifications

General

Damping factor	800
Amplifier class	A
Frequency range	20 - 96000 Hz
Audio output channels	- channels
Peak power per channel	- W
Signal-to-Noise Ratio (SNR)	124 dB
Total Harmonic Distortion (THD)	0.005 %
Dynamic power per channel (4 Ohm)	350 W
Dynamic power per channel (8 Ohm)	160 W
RMS power output per channel (4 Ohm)	150 W
AC (power) in	Yes
USB 2.0 ports quantity	3
Digital audio optical in	2
Digital audio optical out	1
Speakers connectivity type	Banana connector
Purpose	Home
Product color	Black
Volume control	Rotary
Connectivity technology	Wired
Sustainability certificates	RoHS, ENERGY STAR
AC input voltage	100-240 V
AC input frequency	50 - 60 Hz
Power consumption (standby)	0.5 W
Power consumption (typical)	40 W
Certification	CE, TUV

Weight and Dimensions

Depth	388 mm
Width	435 mm
Height	132 mm
Weight	7700 g