26
19. IEC Power Cable Socket: Attach the M15's power cable to this IEC socket first, before
connecting the power cable to the AC-mains outlet. Never disconnect the power cable
from the IEC socket before disconnecting the power cable from the AC-mains outlet.
Failure to follow this procedure may result in a possible electric shock hazard. Always make
sure that the POWER switch is in the OFF position and disconnect the power cable from
the AC-mains outlet, before disconnecting or changing input connections on the back
panel. Failure to follow this procedure may result in possible damage to the either the M15
or other auxiliary equipment.
Note: When connecting or disconnecting audio cables from the back panel of the M15,
disconnect any auxiliary equipment from their AC-mains outlets as well. Failure to
follow this procedure may result in possible damage to the either the M15 or other
auxiliary equipment.
20. POWER switch: The POWER switch supplies the master AC mains power for the M15.
When this switch is in the ON position the M15 is in standby as shown by the amber Status
Condition L.E.D. above the standby switch on the front panel. If you intend not to use the
amplifier for long periods of time (such as when on vacation), switch the POWER switch
to the OFF position.
Note: When the POWER switch is in the OFF position, neither remote control ZR 2, HTR-
M, nor the front panel Power switch will activate the M15.
USING THE M15
Identification of controls
ENGLISH FRANÇAIS
DEUTSCH
NEDERLANDS
ESPAÑOL
ITALIANO
PORTUGUÊS
SVENSKA
To Next Page
Loading...
