543 Color Bar Test
WARNING
-
HIGH VOLTAGE
Color should not need adjusting, but if the white fade test (the bottom
white bar) is tinted an off color, adjustment can be made with the appro-
priate color gun adjustment on the CRT neck board, i.e. RED
-
VR202,
GREEN
-
VR204, BLUE
-
VR206,
or by a qualified Service Technician.
5-5 INITIALIZING CONTROLS
When replacing the game PCB, the ROM, the Steering Assembly, the Gas Pedal
Assembly, or the potentiometer, be sure to follow the procedures below.
(1) Open the coin door.
(2) Remove hands and feet from the steering wheei and the gas pedal.
(3) While in the game screen, hold the credit switch and turn the test switch on at
the same time.
(4) “INITIALIZE COMPLETED” will be shown on the monitor display (see
below), and the adjustment is fished.
(5) Turn the test switch “OFF” to return to the game screen.
SWITCH TEST
DIP SW 12345676
TEST SW ON
COIN1 SW OFF 00
COIN2 SW OFF 00
HANDLE 00
CENTER
THROTTLE 00
BRAKE 00
SHIFT LOW
INITIALIZE COMPLETED
Illustration 5-6, SWITCH TEST SCREEN
11
To Next Page
Loading...