NAMCO FINAL LAP 3 UPRIGHT - Preparing for Operation; Linking Multiple Cabinets

To Next Page

To Previous Page

J122

J121

ONE CABINET

4-2 Preparing the game for operation

If installing a single player FINAL LAP 3 unit, check the following:

Be sure all power is disconnected before making any adjustments.

b. Remove the monitor AC power cord, and plug it into the power supply.

Note the position of the Link PCB Switch located in the recessed metal box

opposite the power supply on the lower back panel of each Monitor Cabinet.

Each FINAL LAP 3 is shipped with the connector switch set for a single

cabinet operation, and should have the slide switch set in the “OUT” position.

Check to make sure it is set to “OUT” (see below).

Illustration 4-2, LINK CONNECTION

ONE CABINET

4-3 Connecting two (2) or more FINAL LAP 3s

Up to eight (8) FINAL LAP 3s can be interconnected (linked) to allow up to eight

(8) players to participate in the same race. When linking two or more games, the

following conditions must be met:

Each FINAL LAP 3 game should be connected to a separate power outlet.

Game difficulty and lap settings must be the same on all monitors in the

linked group. (Ref. 5-3-(2))

All connecting slide switches should be set to the “IN” setting.

Install the link cables between the FINAL LAP 3s by connecting an “OUT”

from one Monitor Cabinet to an “IN” of another game per the following

diagrams. Be sure to seat each plug solidly in its jack.

Perform the self-test by turning the power on to each game. Make sure that

the connections are properly made between games. (Ref. 5-3-1, Self-Test)