7-l-2 HAPP CONTROLS Steering Assembly
NOTE: Numbers shown are Happ Controls Part Numbers.
Illustration 7-3, HAPP STEERING ASSEMBLY
(1) Remove the steering wheel by
taking
off the center cap and removing
the three (3) bolts.
(2) With the wrench provided, remove all four (4) bolts that hold the
plastic cover of the steering assembly.
(3) Open the control panel. (Ref. 7-l)
(4) Disconnect the harness from the steering assembly.
(5) Remove the nuts that hold the steering assembly to take out the
steering assembly.
7-l-3 Replacing the Steering Assembly Potentiometer
Illustration
7-4,
STEERING ASSEMBLY POTENTIOMETER
14
To Next Page
Loading...