Napoleon Ascent Linear Series User Manual

EN
W415-3092 / 07.13.21
11
remote control layout
3.0 remote control layout
3.1 general transmitter layout
3.2 temperature display
Remove the battery cover on the back of the transmitter to expose the °C /
°F dip switch. Move the dip switch to your desired temperature mode.
Selected temperature mode will appear in the top right corner beside the
room temperature.
The receiver switch must be in the REMOTE position for the transmitter to function. This remote system operates
using radio frequency signals sent by the transmitter to the receiver. It is recommended that the distance between
the transmitter and receiver never exceeds 20’ and 10’ if the receiver is located within the fireplace’s outer or inner
cavity surrounding an insert. Low batteries will also affect operational distance.
AAA
AAA
°F °C
TRANSMITTER
REAR VIEW
ON
OFF
LCD
DISPLAY
ON / OFF
BUTTON
THERMOSTAT
BUTTON
UP
BUTTON
DOWN
BUTTON
FLAME
INDICATOR
LOW
BATTERY
INDICATOR
THERMOSTAT
BULB
SIGNAL
INDICATOR
CHILD-PROOF
FUNCTION
INDICATOR
TEMPERATURE
INDICATOR
THERMOSTAT
SET
TEMPERATURE
ROOM
TEMPERATURE
The remote control is optional for the BL36-1 and BL46 models.
note:

Napoleon Ascent Linear Series Specifications

General

Model	Ascent Linear Series
Category	Indoor Fireplace
Fuel Type	Natural Gas or Propane
Viewing Area	Varies by model
Ignition System	Electronic Ignition
Control System	Remote Control
Glass Type	Tempered Glass
Vent Type	Direct Vent
Burner Type	Linear Burner
Dimensions	Varies by model
Weight	Varies by model
Installation Type	Built-in
Log Set	Optional
Warranty	Limited Lifetime Warranty