Napoleon LD485RSIB User Manual (English)

Other manuals for Napoleon LD485RSIB

Questions and Answers:

S
Stacey MartinezJul 26, 2025
Why does my Napoleon LD485RSIB Grill have excessive flare-ups and uneven heat?
- E
  Emily HancockJul 26, 2025
  Excessive flare-ups and uneven heat in your Napoleon Grill can occur due to several reasons. Ensure sear plates are installed correctly with the holes facing the front and the slots at the bottom, following the assembly instructions. Improper preheating can also be a cause; preheat the grill with both main burners on high for 10 to 15 minutes. Lastly, excessive grease and ash buildup on the sear plates and in the drip pan can contribute to this issue. Clean the sear plates and drip pan regularly, and avoid lining the pan with aluminum foil. Refer to the cleaning instructions for proper maintenance.
K
Kyle PriceJul 30, 2025
How to fix low heat or low flame on my Napoleon LD485RSIB Grill when the valve is on high?
- B
  Brandon BarryJul 30, 2025
  If your Napoleon Grill has low heat or a low flame when the valve is turned to high, the cause could be one of several things. For propane grills, ensure you are following the correct lighting procedure, with all gas grill valves in the off position when the tank valve is turned on, and turn the tank on slowly to allow pressure to equalize. For natural gas grills, the supply line might be undersized, so the pipe must be sized according to the installation code. For both propane and natural gas grills, improper preheating could be the issue. Preheat the grill with both main burners on high for 10 to 15 minutes.
T
Tammy HermanAug 3, 2025
Why does the 'paint' appear to be peeling inside the lid of my Napoleon Grill?
- T
  Tiffany BradyAug 3, 2025
  The 'peeling paint' inside the lid or hood of your Napoleon Grill is not a defect. The finish on the lid and hood is porcelain and will not peel. The peeling is caused by hardened grease, which dries into paint-like shards that flake off. Regular cleaning will prevent this. See the cleaning instructions for guidance.
H
hallmichelleAug 7, 2025
What to do if the infrared burner on my Napoleon LD485RSIB Grill flashes back?
- H
  Harold TuckerAug 8, 2025
  If the infrared burner on your Napoleon Grill flashes back, turn the burner off and allow it to cool for at least two minutes. Relight the burner and let it burn on high for at least five minutes, or until the ceramic tiles are evenly glowing red. Ensure that objects or accessories cover no more than 75% of the grill surface. If the issue persists, turn the burner off, let it cool for two minutes, and then relight it. After cooling, inspect the burner closely for cracks. If you find any cracks, contact your authorized Napoleon dealer to order a replacement burner assembly. Also, the ceramic tiles may be overloaded with grease drippings and buildup, or the ports may be clogged. Another possible cause is that the burner overheated due to inadequate ventilation.
R
Robert GrossAug 12, 2025
Why are the burners on my Napoleon Grill burning with a yellow flame and a gas smell?
- W
  Wendy PrattAug 12, 2025
  If the burners on your Napoleon Grill are burning with a yellow flame and there's a smell of gas, it could be due to a spider web or other debris, or improper air shutter adjustment. Thoroughly clean the burner by removing it, following the general maintenance instructions. Slightly open the air shutter according to the combustion air adjustment instructions. This adjustment must be done by a qualified gas installer.
S
Sarah MorrisAug 16, 2025
Why are the flames lifting away from the burner on my Napoleon LD485RSIB Grill?
- J
  Jason FloydAug 16, 2025
  If the flames are lifting away from the burner on your Napoleon Grill, accompanied by the smell of gas, and possibly difficulties in lighting, it is likely due to improper air shutter adjustment. Close the air shutter slightly according to the combustion air adjustment instructions. This adjustment must be done by a qualified gas installer.
M
Matthew BrownAug 20, 2025
Why won't the burners on my Napoleon LD485RSIB Grill cross light each other?
- E
  Elijah PorterAug 20, 2025
  If the burners on your Napoleon Grill will not cross light each other, it is likely due to plugged ports at the back of the burner. Clean the burner ports, following the burner maintenance instructions.

Napoleon LD485RSIB Specifications

General

Cooking Area	485 sq. in.
Burners	4
Side Burner	Yes
Rotisserie Burner	Yes
Material	Stainless Steel
Dimensions	32.5" H x 49.5" W x 24" D
Fuel Type	Propane
BTU	48, 000 BTUs
Ignition Type	Electronic Ignition