NARDA EHP-50-G - Page 3

Contents III
Contents
Page
Safety requirements and instructions…..........…….....…………………
EC Declaration of Conformity ..........................………………................
VII
VIII
1 General information Page
1.1 Documentation......................................................….……..................
1.2 Introduction ……………….....................…………………..…………….
1.3 Configuration and Standard accessories............................................
1.4 Optional accessories ..............................................…………………..
1.5 Main specifications.................................................……….................
1.6 Isotropic E&H field analyzer EHP-50G typical uncertainty
and Anisotropy…………………………………………………………….
1.6.1 Typical uncertainty of EHP-50G………………………………………
1.6.2 Explication Notes……………………………………………………….
1.6.3 Measurements uncertainty of EHP-50G (Weighted Peak mode)…
1.7 Anisotropy………………………………………………………………….
1.8 Overload level…………………………………………………………….
1.9 EHP-50G panel...................................………..………………………..
1-1
1-1
1-3
1-3
1-4
1-5
1-5
1-6
1-7
1-8
1-11
1-12
2 Software interface Page
2.1 Introduction…………….........................................…...………………..
2.2 Preliminary inspection…….............................……...…...…………….
2.3 Work Environment………..........................…………..………………..
2.4 To return for repair…..…..................................……...……………….
2.5 Equipment cleaning………..…….….................……...…..……………
2.6 Power supply and battery recharging………………………................
2.7 EHP-50G connected to a PC……………………………..…………….
2.8 EHP-50G stand alone mode….….………………………..……………
2.9 EHP-50G with 8053B DISPLAY.………………………….……………
2.10 Battery management…………….………………………..…………..
2.11 Avoiding measurement errors……………………………................
2-1
2-1
2-1
2-1
2-1
2-2
2-3
2-3
2-3
2-3
2-4
3 EHP-TS installation Page
3.1 Introduction…………………………………………………..……………
3.2 Hardware requirements…………………………...………..……………
3.3 Installing EHP-TS Software………….………………..…………………
3-1
3-1
3-2