Chapter 2 Installation and BIOS Setup
NI 8352/8353 User Manual 2-16 ni.com
Event Log Capacity
This display informs you of the event log capacity. It is not a setting.
View DMI Event Log
Highlight this item and press <Enter> to view the event log contents.
Event Logging
Use this setting to enable or disable event logging. The options are Enable
(default) and Disable.
ECC Event Logging
Use this setting to enable or disable ECC event logging. The options are
Enable (default) and Disable.
Mark DMI Events as Read
Highlight this item and press <Enter> to mark the DMI events as read.
Clear All DMI Event Logs
Select Yes and press <Enter> to clear all DMI event logs. The options are
Yes and No (default).
Console Redirection
Access this submenu to change the following settings.
COM Port Address
Use this setting to redirect the console to Onboard COM A or Onboard
COM B. The options are Enable and Disable (default).
BAUD Rate
Use this setting to select the BAUD rate for console redirection. The
options are 300, 1200, 2400, 9600, 19.2K (default), 38.4K, 57.6K, and
115.2K.
Console Type
Use this setting to select the console type for console redirection. The
options are VT100, VT100 8bit, PC-ANSI 7bit, PC ANSI (default),
VT100+, and VT-UTF8.
To Next Page
Loading...
Need help?
General
