Index
FP-2000/2010/2015 User Manual I-4 ni.com
monitoring channels, 3-14
mounting on terminal bases, 2-10
No Modules Found error, C-3
powering, 2-13, 2-14
removing, 2-11, 4-3
replacing, 4-3
resetting, B-1
saving configuration as power-up
state, 3-10
writing to an output channel, 3-15
iak file, 3-14
icon, 3-11, 3-14, 3-15
installation
category, 2-2
connecting to network, 2-11
FieldPoint software, 2-15, D-1
HotPnP (Hot Plug and Play), 4-3
LabVIEW RT, 2-15, D-1
mounting hardware on DIN rail
connecting terminal bases, 2-6
mounting FP-20xx,2-4
removing FP-20xx and terminal
bases, 2-6
mounting hardware to a panel
connecting terminal bases, 2-8
FP-20xx mounting procedure, 2-7
panel mount accessory, 2-7, 2-8
panel mount accessory (figure), 2-8
removing FP-20xx and terminal
bases, 2-10
mounting I/O modules onto terminal
bases, 2-10
overview, 1-4
power connections, 2-13, 2-14
figure, 2-14
removing I/O modules, 2-11
Installer Settings tab in Application
Builder, 5-10
instrument drivers, F-1
IP Access List, 3-12, 3-13
IP address
See also gateway IP address; DNS
address; time server; subnet mask
choosing, A-1
configuring, 3-3
error when configuring, C-2
resetting with Reset switch, 4-7, B-1
IP Pattern, 3-13
isolation
defeated by cascading power
caution, 2-13
figure, 2-14
K
KnowledgeBase, F-1
L
LabVIEW RT
See also Application Builder
disabling engine with Safe Mode
switch, 4-7
embedded applications. See embedded
applications on FP-20xx
installation, D-1
network options, 5-3
programming, 5-1
RTEngine,1-1,4-7,5-3,5-4,5-8,5-11
RT Target Access options, 5-4
RT Target Miscellaneous options, 5-6
targeting LabVIEW RT
to a platform, 5-1
to host PC, 5-3
LabVIEW VIs
Disable VI switch, 4-6
embedded applications. See embedded
applications on FP-20xx
FieldPoint VIs, 3-17
hardware watchdog VIs, 5-11
LabVIEW FieldPoint VIs, 4-7
To Next Page
Loading...
