National Instruments FieldPoint FP-2000 - Page 92

Index
© National Instruments Corporation I-5 FP-2000/2010/2015 User Manual
launching VIs at system startup, 5-6, 5-10
Publish Data VI, 3-23
runaway startup applications, C-4
serial VIs, 3-23
specifying download path, 5-6
specifying target with command line
arguments, 5-7
TCP, 3-23
UDP VIs, 3-23
LabWindows/CVI software, 3-18
LED indicators, 4-4
power-on self test (POST), 2-15, 4-5
LINK LED, 4-5
local bus connector, protective cover (figure),
2-6, 2-10
Lookout software, 3-16
M
100 Mbps LED, 4-5
memory specifications, E-1
modules. See FP-20xx hardware; I/O modules
monitoring I/O channels, 3-14
mounting hardware on DIN rail. See
installation, mounting hardware on DIN rail
mounting hardware to a panel. See installation,
mounting hardware to a panel
N
National Instruments
calibration certificate, F-2
customer education, F-1
Declaration of Conformity, F-1
professional services, F-1
system integration services, F-1
technical support, F-1
worldwide offices, F-2
network module. See FP-20xx hardware
network security settings, 3-12
network specifications, E-1
network watchdog, 4-1
network. See Ethernet network
O
online technical support, F-1
OPC client, 3-19, 3-20
OPC server, 3-19, 3-20
overview
FieldPoint software, 1-3
FP-20xx hardware, 1-1
setup, 1-4
using FP-20xx from host
applications, 3-16
P
panel mount. See installation, mounting
hardware to a panel
password, locking/unlocking configuration in
Remote System Explorer, 3-13
password-protected resets, 3-4, B-1
phone technical support, F-2
physical characteristic specifications, E-2
pollution degree, 2-2
power connections
calculating power for FieldPoint
bank, 2-14
figure, 2-14
wiring, 2-13
POWER LED, 4-4
power requirement specifications, E-1
power supply, 2-13
power-on self test (POST), 2-15, 4-5
power-up
launching LabVIEW RT applications at
system startup, 5-6, 5-10
overview, 2-15
runaway startup applications, C-4
power-up state, configurable, 4-3