National Instruments FieldPoint FP-2000 - Page 93

Index
FP-2000/2010/2015 User Manual I-6 ni.com
professional services, F-1
programming examples, F-1
R
rail clip, 2-4, 2-7
registering computers
with Lookout, 3-16
with OPC, 3-19
Remote System Explorer
features and options, 3-11
locking/unlocking configuration, 3-13
troubleshooting browse errors, C-1
troubleshooting No Software Installed
status, C-3
removing FP-20xx and terminal bases
DIN rail mount, 2-6
panel mount, 2-10
Reset switch, 4-7, B-1
resetting a FieldPoint bank, 3-4, 4-7, 5-11, B-1
RS-232 serial port, 1-1, 3-23, 4-7
RT Engine. See LabVIEW RT; RT Engine
RT Target Access options, 5-4
RT Target Miscellaneous options, 5-6
S
safe mode, 4-7
Safe Mode switch, 4-7
safety information, 2-1
safety specifications, E-2
saving current state of FieldPoint bank, 4-2
saving system configuration, 3-14
security
locking/unlocking Remote System
Explorer settings, 3-13
network security settings, 3-12
password-protected resets, 3-4
serial data communication, 3-23
serial port, 1-1, 3-23, 4-7
serial VIs, 4-7
snapshot feature, 3-10, 4-2
software drivers, F-1
specifications
cabling, E-3
electromagnetic compatibility, E-2
environmental, E-2
memory, E-1
network, E-1
physical characteristics, E-2
power requirements, E-1
safety, E-2
STATUS LED, 4-4
STATUS LED error indications (table), C-4
subnet mask
choosing values, A-1, A-2
configuring, 3-3
resetting with Reset switch, B-1
support
technical, F-1
switches
DIP switches, 4-6
DIP switches 1 through 5, 4-7
system integration services, F-1
T
TCP data communication, 3-23
TCP/IP settings, A-4
technical support, F-1
telephone technical support, F-2
terminal bases
connecting with DIN rail mount, 2-6
connecting with panel mount, 2-8
powering, 2-13
removing with DIN rail mount, 2-6
removing with panel mount, 2-10
testing
power-on self test (POST), 4-5
verifying configuration in FieldPoint
Explorer, 3-14