Appendix A Device-Specific Information
© National Instruments Corporation A-55 E Series User Manual
For a detailed description of each signal, refer to the I/O Connector Signal
Descriptions section of Chapter 1, DAQ System Overview.
NI 6034E/6035E/6036E Family
The NI 6034E/6035E/6036E are Plug-and-Play, multifunction AI, AO,
DIO, and TIO devices.
The NI 6034E features the following:
• 16 AI channels (eight differential) with 16-bit resolution
• Eight lines of TTL-compatible DIO
• Two 24-bit counter/timers for TIO
• A 68-pin I/O connector
The NI 6035E features the following:
• 16 AI channels (eight differential) with 16-bit resolution
• Two AO channels with 12-bit resolution
• Eight lines of TTL-compatible DIO
• Two 24-bit counter/timers for TIO
• A 68-pin I/O connector
The NI 6036E features the following:
• 16 AI channels (eight differential) with 16-bit resolution
• Two AO channels with 16-bit resolution
• Eight lines of TTL-compatible DIO
• Two 24-bit counter/timers for TIO
• A 68-pin I/O connector
Because the NI 6034E/6035E/6036E devices have no DIP switches,
jumpers, or potentiometers, you can easily configure and calibrate them
through software.
The DAQCard-6036E is a low-power AI, AO, DIO, and TIO card for
computers equipped with a Type II PC Card slot. The low power
consumption of the DAQCard-6036E makes this card ideal for use in
portable computers and makes portable data acquisition practical.
To Next Page
Loading...
