Chapter 2 Installation and Configuration
© National Instruments 2-3 NI PXI-8109 User Manual
7. Raise the injector/ejector handle until the module firmly seats
into the backplane receptacle connectors. The front panel of the
NI PXI-8109 should be even with the front panel of the chassis.
8. Tighten the four bracket-retaining screws on the top and bottom of the
front panel to secure the NI PXI-8109 to the chassis.
9. Check the installation.
10. Connect the keyboard and mouse to the appropriate connectors. If you
are using a PS/2 keyboard and a PS/2 mouse, a Y-splitter adapter is
available to connect both to a single USB connector. Refer to
Figure 4-1, Y-Splitter Cable.
11. Connect the DVI monitor video cable to the DVI connector, or use the
DVI-to-VGA adapter included with your controller to connect a VGA
monitor to the DVI connector. Connect devices to ports as required by
your system configuration.
12. Power on the display device.
13. Power on the chassis.
14. Verify that the controller boots. If the controller does not boot, refer
to the What if the NI PXI-8109 does not boot? section of Chapter 5,
Troubleshooting.
To Next Page
Loading...
