National Instruments sbRIO-9607 - Power and Feature Utilization

LED Pattern Indication
Blinks four times and pauses The sbRIO-9607 is in safe mode. The soware
has crashed twice without rebooting or cycling
power between crashes.
Continuously blinks The sbRIO-9607 has not booted into NI Linux
Real-Time. The sbRIO-9607 either booted into
an unsupported operating system, was
interrupted during the boot process, or
detected an unrecoverable soware error.
On momentarily The sbRIO-9607 is booting. No action required.
O The sbRIO-9607 is in run mode. Soware is
installed and the operating system is running.
Where to Go Next
SUPPORT
Services
ni.com/services
NI Community
ni.com/community
NI Training
ni.com/training
Support
ni.com/support
SOFTWARE
CompactRIO Examples
NI Example Finder
Conguring a Project
NI Compact RIO Device Help
Learn LabVIEW Basics
ni.com/gettingstarted
NI Single-Board RIO CLIP
Generator Help–Reference
for the sbRIO CLIP Generator
application
ni.com/singleboard/setup
Tutorials, demos, and videos
for getting started with
NI sbRIO devices
HARDWARE
NI 9697 Installation
Instructions
ni.com/manuals
NI sbRIO-9607/9627
RMC Design Guide
ni.com/manuals
NI sbRIO-9607 User Manual
ni.com/manuals
NI sbRIO-9607 Specications
ni.com/manuals
Software Support
ni.com/info swsupport
Worldwide Support and Services
© National Instruments
13
sbRIO-9607 Getting Started