6. MIXING YOUR FIRST TRACKS
In this section you will learn to mix your first two tracks, using Deck A and Deck B, with the SYNC
function. For this method, you will not need to use the Jog Wheels or your headphones.
At first you will prepare the Mixer by adjusting the control elements for mixing tracks between Deck
A to Deck B. Then you will load the first track into Deck A, and begin to perform step by step.
6.1. Prerequisites
1. Set Crossfader Assignment selector A to the left to assign Mixer channel A to the left cross-
fader end.
2. Set Crossfader Assignment selector B to the right to assign Mixer channel B to the right
crossfader end.
3. Set the crossfader to the left-most position.
4. Set channel fader A and channel fader B to maximum position.
Mixing Your First Tracks
27
To Next Page
Loading...
