• Set the crossfader curve selector to the center position.
If you want the crossfader to use the sharp curve:
• Set the crossfader curve selector to the right.
7.4. Adjusting Levels
When you mix tracks you need to make sure that the levels of both tracks are at the same level for
flawless transitions. But also, you need to make sure the signals are not to loud neither to silent to
gain the best possible audio quality. For this, you can define the level for the incoming audio sig-
nals into the Mixer channel, and you can define the levels for the outgoing signals send to the
MASTER output.
Adjusting Levels for Incoming Audio Signals
With the GAIN knob in the Mixer channel you can determine the level for the incoming audio sig-
nal. When you adjust the incoming level the Channel Volume Meter visually indicates the current
level.
To adjust the level for the incoming audio signal in the Mixer channel:
• Turn the individual GAIN knob clockwise or counterclockwise so that the incoming level does
not exceed the Headroom area reflected by the yellow LEDs of the Channel Volume Meter.
Adjusting Outgoing Mixer Channel Levels
The channel fader in a Mixer channel limits the maximum level sent from the Mixer channel to the
MASTER output.
Tutorials
45
To Next Page
Loading...
