Native Instruments TRAKTOR KONTROL S4 - Playing with FX Units

Applying MIXER FX to the Audio Signal
To apply the selected MIXER FX, in combination with a low-pass Filter, to the audio signal:
• Turn the MIXER FX Amount knob counterclockwise.
To apply the selected MIXER FX in combination with a high-pass Filter to the audio signal:
• Turn the MIXER FX Amount knob clockwise.
If the FILTER is selected, turning the MIXER FX Amount knob only applies a low-pass Filter or a
high-pass Filter to the audio signal.
7.13. Playing with FX Units
In this section you learn how to assign FX Units to Mixer channels and how to control individual
effect parameters.
In TRAKTOR you can use the FX Units in the Global section to modulate the audio signals in the
Mixer channels. You can directly control the parameters of FX Unit 1 and 2 in the software using
the controls of the corresponding FX Unit 1 and 2 on the S4. In the software the FX Units are free-
ly configurable, whereas on the S4 you can only control the effect parameters that are assigned in
the software.
Assigning FX Units to Mixer Channels
To assign FX Units to the Mixer channels:
• Press the FX Unit Assign buttons for the corresponding FX Unit in the Mixer channel. The left
FX Unit Assign button assigns FX Unit 1, and the right FX Unit Assign button assigns FX Unit
2.
Tutorials
61