NV10LT/NV7.5LT INSTALLATION MANUAL CONNECTING AC POWER
VERSION 5.0 2021-03-01 PAGE 2.5.3
11. If the UPS interface option has been installed, route the ac cable from the user-provided UPS,
through the desired top or bottom entry point (see Figure 2.5.1 on page 2.5.4), to the UPS interface
assembly at the bottom of the transmitter. Install the Nautel provided mating connector and install
the ac cable on the UPS interface assembly. Refer to “Configuring an External UPS” on page 2.9.11
to configure the transmitter to recognize the UPS. See the NV10LT/NV7.5LT Pre-installation Manual
for more information.
12. Re-install the grilled panel that was removed in Step 2, using four M4 screws.
13. Re-install the bottom rear panel removed in Step 1, using the retained M5 screws.
14. Do not install the rear filter panel at this time.
To Next Page
Loading...
