Nautel VX Series - Control and Monitor Wiring; Front Panel UI Control

VX3 TO VX6 INSTALLATION MANUAL CONTROL AND MONITOR WIRING
VERSION 1.0 2023-08-16 PAGE 1.8.1
SECTION 1.8: CONTROL AND MONITOR WIRING
This section describes the types of control and monitoring for the VX3 to VX6. All connections are made
to the rear panel of the transmitter (see VX3 to VX6 - Control/Monitor Connections on
page 1.8.11). Consider the following information and plan for the necessary requirements (wiring,
remote switches/ indicators, LAN, etc.):
 Front Panel UI Control
 Remote Inputs - see page 1.8.2
 Remote Outputs - see page 1.8.4
 Analog Outputs - see page 1.8.6
 Web Based AUI Control - see page 1.8.7
 SNMP Control/Monitoring - see page 1.8.8
 Email Server - see page 1.8.8
 USB - see page 1.8.8
 RF Drive Sample - see page 1.8.8
 External Interlock - see page 1.8.9
NOTE: This section provides the information required to determine your control and monitor wiring and
plan for their connection to the transmitter. Physical connections are made in
Completing External
Connections on page 1.10.1 .
Front Panel UI Control
The VX3 to VX6’s front panel user-interface (UI) lets you locally control a number of transmitter
functions and set parameters.
For detailed information about the front panel UI, refer to the VX Operation and Maintenance Manual.
In addition, the front panel UI lets you define and control the on/off status, the preset RF power level,
and protection reset for latched alarms remotely using a conventional remote control interface (see
Remote Inputs - see page 1.8.2 and Remote Outputs - see page 1.8.4) or a LAN (see Web Based AUI
Control - see page 1.8.7.