Nautilus E614 User Manual

21
To reduce the risk of electrical shock or unsupervised usage of the equipment, always unplug the power cord from the wall outlet and the
machine and wait 5 minutes before cleaning, maintaining or repairing the machine. Place the power cord in a secure location.
Note: Your machine may not match the image. For reference only.
1. Using a #2 Phillips screwdriver, remove the 4 indicated screws from the
Console Assembly.
2. Gently lift the Console Assembly and disconnect the cables.
NOTICE: Do not crimp the cables. Do not allow the cables to fall down
the Console Mast. Use a rubber band or wire tie.
This step may require two people.
3. Using a Phillips screwdriver, remove the 3 indicated screws and remove
the Water Bottle Holder.
4. Using a 6 mm hex key, remove the 3 indicated bolts and remove the
Static Handlebar.
NOTICE: Do not crimp the cables when removing the Static Handlebar.
Do not allow the cables to fall down into the Console Mast. Use
a rubber band or wire tie.
5. Installation is the reverse procedure.
NOTICE: Do not crimp the cables.
6. Dispose of the old parts.
7. Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner’s Manual.
#2
X3
X3
6mm

Nautilus E614 Specifications

General

Brand	Nautilus
Model	E614
Category	Elliptical Trainer
Language	English