Nautilus E614 - Page 24

24
X2
13 mm
X2
6mm
5. Using a small Flathead screwdriver, pry the Caps from the Lower
Handlebar Arms.
6. Using a 13 mm wrench, remove the hardware from
the Lower Handlebar Arms and the Arm Pivot. Remove
the Handlebar Arms and set them safely aside.
7. Installation is the reverse procedure.
Make sure the Upper Handlebar Arms are secure before you
exercise.
8. Discard the old parts.
9. Inspect your machine to ensure that all hardware is tight and compo-
nents are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the Owner’s
Manual.