28
Note: Your machine may not match the image. For reference only.
NOTICE: This procedure requires two or three people.
1. Place a static object (like a book or box) under the front of the main
frame but not under the Front Stabilizer. The static object should not be
compressible.
2. Loosen and remove the 2 bolts that attach the Front Stabilizer using a
6 mm hex key. Remove the Front Stabilizer.
3. Installation is the reverse procedure.
4. Dispose of the old part.
5. Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the Owner’s
Manual.
6mm
X2
To reduce the risk of electrical shock or unsupervised usage of the equipment, always unplug the power cord from the wall outlet and the
machine and wait 5 minutes before cleaning, maintaining or repairing the machine. Place the power cord in a secure location.
To Next Page
Loading...
Need help?
General
