49
MAINTENANCE
Read all maintenance instructions fully before you start any repair work. In some conditions, an assistant is required to do the
necessary tasks.
Equipment must be regularly examined for damage and repairs. The owner is responsible to make sure that regular
maintenance is done. Worn or damaged components must be repaired or replaced immediately. Only manufacturer
supplied components can be used to maintain and repair the equipment.
If at any time the Warning labels become loose, unreadable or dislodged, contact your local distributor for replacement
labels.
To reduce the risk of electrical shock or unsupervised usage of the equipment, always unplug the power cord
from the wall outlet and the machine and wait 5 minutes before cleaning, maintaining or repairing the machine. Place the
power cord in a secure location.
Daily:
Before each use, examine the exercise machine for loose, broken, damaged, or worn parts.
Do not use if found in this condition. Repair or replace all parts at the first sign of wear or
damage, except for the Walking Deck. The Walking Deck is designed for wear on both sides
of it. If only one side of the Walking Deck is worn, a replacement Deck is not required. It is
recommended that a qualified service technician is used to flip the Walking Deck. After each
workout, use a damp cloth to wipe your machine and Console free of moisture.
With the Walking Deck lowered, if an edge of the Walking Belt can be seen adjust it
until the edge is not viewable.
Note: Avoid excessive moisture on the Console.
Weekly:
Check for smooth roller operation. Wipe the machine to remove dust, dirt, or grime.
Do not remove the Motor Control Board (MCB) Cover, dangerous voltages and moving
parts are present. The components are serviceable only by approved service person-
nel.
Note: Do not use petroleum based products.
Monthly
or after 20 hours:
Make sure all bolts and screws are tight. Tighten as necessary.
Quarterly:
Or after 25 hours—Lubricate the walking belt with a silicone-based lubricant.
NOTICE: Do not clean with a petroleum based solvent or an automotive cleaner. Be sure to keep the Console free of
moisture.
Cleaning
To reduce the risk of electrical shock, always unplug the power cord and wait 5 minutes before cleaning,
maintaining or repairing this machine.
Wipe the treadmill down after each use to keep the treadmill clean and dry. It may be necessary to use a mild detergent at
times to remove all dirt and salt from the belt, painted parts and the display.
NOTICE: To prevent damage to the finish of the machine or Console, do not clean with a petroleum based solvent. Do
not apply too much moisture to the Console.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
