Page 10 Naxa Electronics
Connecting Power
Use the included AC power adapter to connect the unit
to AC household power.
• Connect the two-pronged end of the adapter to a
household power outlet.
• Connect the barrel plug end of the adapter to the
Power socket [7] of the unit.
⚠⚠
The adapter supports AC 100-240V power
only. Do not connect the power adapter to
a power outlet other than that which is in-
dicated here and on the rating label of the
power adapter as this may result in the risk
of re or electric shock.
Disconnect the unit from power if it will not
be used for a long time.
Do not handle the power plug with wet
hands. Doing so may cause electric shock.
Do not use the adapter with any other power
source.
Getting Started
Turning the Unit On and O
To turn the unit on, press and hold POWER/SOURCE [8].
To place the unit in Standby mode, press and hold
POWER/SOURCE [8] until the SOURCE LED [2] turns red.
To turn the unit off completely, disconnect the unit
from power.
Setting the Source Mode
Press POWER/SOURCE [8] to set the active source
mode. This controls which connection is being used.
The SOURCE LED [2] will light to indicate which mode
has been selected when POWER/SOURCE [8] is pressed.
Source LED Connection Mode
Blue Bluetooth
®
Indigo Optical In audio input [4]
To Next Page
