Naxa NHS-2011 - Using Bluetooth Mode; Pairing a Bluetooth Device

www.naxa.com Page 11
Source LED Connection Mode
Violet AUX IN 1: 3.5mm audio
input [5]
Orange AUX IN 2: RCA stereo
input [6]
Adjusting the Volume
• Use the VOL– and VOL+ keys [9, 10] to decrease or
increase the volume level, respectively.
• Press the MUTE key on the remote to disable sound
output completely. Press the MUTE key again to
restore sound output.
Using Bluetooth
®
Mode
Press SOURCE to set the active mode to Bluetooth.
Pairing a Bluetooth
®
Device
You will need to pair your Bluetooth device with the
sound bar the rst time you use them together.
1. Press the POWER/SOURCE button [8] until the
Source LED turns blue.
2. Enable Bluetooth on the source device and use it
to search for other Bluetooth devices. (Refer to the
user manual of your device if you need help with
this step.) Select the NAXA NHS-2011 sound bar
when the device nds it. If the device prompts you
for a pass code, enter “0000”.
3. After a successful pairing, you will be able to stream
music wirelessly from your source device to the
sound bar. Some devices may allow you to control
playback from the sound bar; otherwise, control
playback on the device.
4. If the pairing attempt fails, the sound bar may have
timed out. Try starting the pairing procedure again