NComputing L130 User Manual

NComputing L-Series User Manual rev.05.07.12
Page 73 of 95
4.0 USB Assignment
Left-click on the “USB Assignment” section of the left navigation tree to display information on USB
controllers available to the host. From this interface, you can assign individual USB ports to specific user
sessions. By default, most USB ports on the host and the peripherals attached to them are visible and
available for use by any user (provided the peripherals themselves are multi-user aware).
It is important to select USB ports that are not currently in use. Ports not in use are identified by the text
“No device connected.” If you select a USB port in use, you might accidently disable or restrict one of
the ports servicing the host’s keyboard, mouse or other USB peripheral. Once you have selected an open
USB port, the following settings on the right side of the console will display:
Available to All
Stations
This setting is enabled by default, and allows all devices to see a given USB port
and access devices connected to it if those devices support multi-user
environments. This setting must be disabled to enable the other two options.
Available on Host Restricts the port to use by the host session only.
Assigned to
Following
Devices:
Allows administrators to decide which user session(s) have access to a given USB
port.

NComputing L130 Specifications

General

Brand	NComputing
Model	L130
Category	Wireless Access Point
Language	English